66
4. Set the IP address to an unused IP address belonging to the same network segment as that
of CPE1. For example, if the IP address of the CPE1 is 192.168.2.1, you can set this device’s
IP address to 192.168.2.X (X ranges from 2 to 254). Then click Next.
5. Click Save, and wait until the device reboots to activate the settings.
Step 3 Perform Step 1 and Step 2 above to change the wireless settings of CPE3, whose SSID is
Tenda_2 in this example, set it to Repeater mode, and bridge to CPE1.
Step 4 Set CPE1 to P2MP mode and bridge to CPE2 and CPE3.
1. Log in to the web UI of CPE1, and choose Quick Setup to enter the configuration page.
2. Select P2MP mode, and click Next.
To Next Page
Loading...
Need help?
General
