62
7. Click Save, and wait until the device reboots to activate the settings.
----End
To check whether the bridging is successful:
Method 1: When the LED1, LED2, and LED3 indicators of the CPEs are solid on, the bridging
succeeds.
Method 2:
Step 1 Start a web browser on the computer which is connected to the CPE1 and visit its IP
address.
Step 2 Choose Advanced > Diagnose, select Ping from the Diagnose drop-down list menu, enter
the IP addresses of the CPE2, CPE3, CPE4 and CPE5 respectively and click Start.
The bridging is successful when the ping succeeds.
Parameters description
It specifies the working mode of this device.
P2MP mode: In this mode, the device can connect 2 or more (this device supports 4 at
most) wired networks with a wireless link, but cannot be connected with wireless
clients. P2MP mode is used to achieve communication between multiple offices of an
enterprise in a city.
It specifies the wireless network name (SSID) of the peer AP.
It specifies the operating channel of the WiFi network to be bridged. It will be
automatically populated when you select an SSID to bridge.
It specifies the security mode of the WiFi network to be bridged. It will be automatically
populated when you select an SSID to bridge.
The P2MP mode only supports WEP and None security modes.
To Next Page
Loading...
Need help?
General
