Tenda I-WL-O3 - How to Clone MAC Address

31
3 Advanced Settings
How to Clone MAC Address
In general, if you cannot access the Internet via your connected computer or smart-phone,
meanwhile you find you can only access the Internet via a specified computer directly without a
router, you can try cloning the MAC address on the MAC Clone page. It is especially useful if
your ISP only assigns one valid IP address and it is associated to a specific MAC address. This is
usually used by cable operators or some WISPs. Note that this function is only available in
Router mode.
Click Network > MAC Clone to enter page below.
 If the specified computer connected to your device via an Ethernet cable, and you configure
the router on the specified computer, follow the steps below:
❶ Click Clone MAC and the specified computer’s MAC address will be entered in the MAC
Address field.
❷ Click Save.
 If the computer connected to your device is not the specified computer, follow the steps
below:
❶ Enter the MAC address of the specified computer in the MAC Address field.
❷ Click Save.
Other Options may help:
Default MAC: Click it to restore the current MAC address to factory default MAC of the Router.
Clone MAC: Click it to copy the MAC address of the connected computer to the MAC Address
field.