Tenda I-WL-O3 - Quick Installation Guide; Step 1: Connect an Ethernet Cable to the AP; Step 2: Install the AP

5
2 Quick Installation Guide
2 Quick Installation Guide
Step 1: Connect an Ethernet Cable to the AP
❶ Slide the bottom cover of the AP down to expose the ports.
❷ Connect an Ethernet cable (≤ 60m), which will be connected to the PoE injector, to the PoE
LAN/WAN port of your AP.
❸ Gently replace the cover by sliding it up until it clicks into place.
Step 2: Install the AP
Set up the AP in an outdoor location, usually
on the roof, and thread plastic wraps through
grooves underneath the brackets. Then
attach the device firmly to a solid pole.