N3 11N Wireless Broadband
Router User Manual
4.8 Statistics
Statistics dynamically displays bandwidth usage by PCs on your
LAN.
● Enable Traffic Statistics: Check the box to gather bandwidth usage by
PCs on your LAN. It is disabled by default. Disabling this option may
boost router’s packet processing capacity. When enabled, system will
dynamically renew statistics information every 5 seconds.
● IP Address: Displays IP address information of a corresponding
statistics item.
● Uplink Rate: Displays how many Kbytes of data have been transmitted
per second.
● Downlink Rate: Displays how many Kbytes of data have been
received per second.
● Sent Message (TX Packets): Displays the total number of packets
transmitted by a corresponding IP address through the router.
Sent Bytes: Displays how many Mbytes of data have been transmitted by
a corresponding IP address through the router.
Received Message (RX Packets): Displays the total number of packets
received by a corresponding IP address from the router.
● Received Bytes: Displays how many Mbytes of data have been
received by a corresponding IP address from the router.
4.9 WAN Speed
This section allows you to configure WAN speed. Default settings are
32
To Next Page
Loading...
