N3 11N Wireless Broadband
Router User Manual
recommended.
● AUTO: DO NOT change this default setting unless you are connecting
an excessively long Ethernet cable from your ISP, which may degrade
drive capability, to the router’s WAN port.
● 10M HALF-duplex: Select it if your router’s WAN port does not function
properly when connected to an Ethernet cable from your ISP; excessive
length of the cable may degrade drive capacity of the WAN port.
● 10M FULL -duplex: Select it to set router’s WAN port to work at
10Mbps in full duplex mode, improving WAN port drive capacity.
● 100M HALF-duplex: Select it to set router’s WAN port to work at
100Mbps in half duplex mode.
● 100M FULL-duplex: Select it to set router’s WAN port to work at
100Mbps in full duplex mode.
Chapter 5 Wireless Settings
5.1 Basic Settings
33
To Next Page
Loading...
