instructions:
Put the switch in clean place where there is adequate ventilation
Place the switch on stable desk in case of falling.
Make sure there’s at least 10cm’s space for dissipation.
Don’t put heavy articles on the Switch.
When the devices need to be used by overlapping, make sure the
vertical distance is over 1.5cm.
The power supply used should match the required power
specification of the switch.
2.2 Installation methods
TEG1016G/TEG1024G switch can be installed to desktop or standard
19-inch rack
1. Install the switch to the desktop.
Install the 4 included foot pads to the corresponding position at the
bottom of the switch and then place it on the desktop.
To Next Page
Loading...
