To Next PageTo Next PageWhat to do if the pad motor does not operate on my Tennant Floor Machine?
If the pad motor on your Tennant Floor Machine isn't working, consider these possibilities: * If the pad motor circuit breaker is tripped, replace the pad or adjust the pressure and reset the breaker. * Ensure the machine is not tilted back on its rear wheels; lower it from the tilt position.
What to do if my Tennant Floor Machine has no power?
If your Tennant Floor Machine has no power, there are several potential causes to investigate: * Check for loose battery cables and tighten them if necessary. * Ensure the battery cables are properly connected. * If the main circuit breaker is tripped, determine the cause and reset it. * Make sure the battery charger is disconnected. * If equipped, verify the emergency stop switch is not activated; turn the button to reset it. * Replace faulty batteries.
Why does my Tennant Floor Machine have a short run time?
A short run time in your Tennant Floor Machine can be due to several reasons: * The battery charge may be low, so charge the batteries. * There may be defective battery cells, in which case you should replace the battery. * Consider replacing faulty battery charger.
General| Brand | Tennant |
|---|---|
| Model | 2510 |
| Category | Floor Machine |
| Language | English |
