IB 340480 (5-01) 1
No. 340480
Machine: 6100, 6200
Published: 5-01/00
System: SWEEPING
INSTRUCTION BULLETIN
NOTE: DO NOT DISCARD the Parts List from the Instructi on Bulletin. Place the Parts
List in the appropriate place in your machine manual for future reference.
Retaining th e Parts List will make it easier to reorder individual parts an d will
save you the co st of ordering an entire kit.
NOTE: Numbers in parenthesis ( ) are reference numbers for parts listed in Bill of Materials.
Installation instructions for kit number 384169
SYNOPSIS / PROBLEM:
This kit contains the parts needed to replace the damper solenoid on the model
sweeper/scrubber.
Please follow step-by-step instructions.
SPECIAL TOOLS / CONSIDERATIONS: 1/2” Rounded file
(Estimated time to complete: 1 hour)
PREPARATION:
(Refer to FIG. 1 thru 4)
FOR SAFETY: Before leaving or servicing machine, sto p on level surface and set parking
brake. T h en turn off machine and remove key.
1. Raise the operator seat and secure in place with the seat support rod.
2. Disconnect battery cables from machine.
WARNING: Always disco n n ect battery cables from machine before working
on electrical components.
6100 INSTALLATION:
(Refer to FIG. 1 and 2)
1. Remove the hopper from the rear of the m achine.
2. Unlatch and lower the filter to gain access to the damper solenoid.
3. Disconnect the solenoid from the main wire harness.
4. Locate the damper solenoid m ounted on the side of the damper. Remove and discard the
pin retainers, both retaining pins and the connecting link. (Refer to FIG. 1)
5. Remove and discard the solenoid from the weldment on the side of the cylinder.
(Refer to FIG. 1)
To Next Page
General
