36
3. Routine maintenance
3.1. Daily inspections
1) Before riding, check whether the screws in the following key parts are properly
tightened:
(1) Screws between the handlebar and the front fork stem
(2) Screws between the stem and the handlebar
(3) Screws between the brake lever and the handlebar
(4) Screws between the brake clamps and frame or front fork
(5) Screws between the discs and bottom brackets
2) Use the tools provided to tighten any loose screws.
3) If you live near the seaside, apply a tiny bit of oil around the bolts regularly to
prevent rusting.
4) After all screws are properly tightened before the first ride, check if they maintain
the same fastening performance when your e-bike reaches a 200 km riding
distance and at every 1,000 km after the initial 200 km.
5) It is recommended to check the fastening performance of screws at every 600 km if
you usually ride under complex road conditions.
3.2. Daily cleaning
1) Use a rag or large brush to clean off dust when there is not much mud on your
e-bike.
2) When there is a lot of mud on your e-bike, use a brush dipped into soapy water to
wash it off, rinse it with a little clean water, and then dry it with a soft cloth.
3) Check the wear degree of the brake blocks after you have them cleaned to see if
they can ensure normal braking. Replace them promptly if they are seriously worn.
4) It is recommended to clean the e-bike after you ride it for about 200 km. You need
to clean the bike first before you put it into storage if you plan to not ride for a long
period of time.
Attention: Do not clean the bike with a high-pressure water gun, as this might damage
the mechanical pivots and related mechanical fitting parts.
To Next Page
Loading...
