Routine maintenance
It is recommended to go to a professional store for maintenance 2-3 times a quarter,
or after every 1,000 km of riding. The following items should be checked during such
maintenance:
Operating and storage temperatures of the battery
Working temperature of the lithium battery is 0°C to 30°C.
It is recommended that the lithium battery be stored in an environment where
the temperature is 0°C to 25°C, and the humidity is 65 ± 20% RH.
The performance of lithium batteries is affected by the ambient temperature.
Don't worry if the performance of your battery degrades during cold weather. The
battery performance will resume when the temperature rises.
If possible, the battery should not be charged above 95% or discharged below 10%,
as this may decrease battery life. A reasonable charging and discharging scheme
can mitigate accelerated battery deterioration.
Keep the power at 50% to 70%, check the battery condition every 2 months to
avoid damage caused by over-discharging, charge and discharge the battery every
3 months if it is not used for a long time.
The new brake blocks and discs feature relatively smooth surfaces, so the braking
effect will improve after you ride 100 km or brake on long downhills 3 to 5 times,
when such surfaces are roughened.
Check screws between the brake lever and the handlebar, as well as screws
between the brake clamps and frame or front fork:
The wear degree of brake blocks should be checked after you’ve ridden on normal
roads for 1,000 km, or 600 km if the road conditions are complex. The blocks
should be replaced promptly when two thirds or more are worn.
Contact a professional store and ask technicians to replenish the lubricant after
you conrm that there is no sign of oil leakage on the brakes when you feel that
they are obviously softened even though their wear degrees are still acceptable.
Contact a professional store and ask technicians to find out the cause of any
abnormal noise and come up with a solution if you notice obvious abnormal noise
during riding and the problem persists after you clean the oil on the brake blocks
and discs.
Performance of the hydraulic brakes.
The fastening performance of screws, especially those between the discs and
bottom brackets, in key parts.
The wear degree of the head parts.
The wear degree of the front hub bearings.
The wear degree of the pedal pivots.
The professional store should lubricate the internal pivots to ensure the
smoothness of pivots in front fork parts, front hub bearings, bottom bracket, and
other parts.
The wear degree of the tires.
The fastening performance of the bottom bracket torque sensor, battery, controller,
motor, display, and other electronic control parts.
i. Check if these screws maintain the same fastening performance when your e-bike reaches a
200 km riding distance
ii. Check the fastening performance at every 1,000 km after the initial 200 km.
iii. It is recommended to check the fastening performance of screws at every 600 km if you
often ride under complex road conditions
Routine maintenance
Professional store maintenance
How to maintain the battery
How to maintain the brakes
28 29
To Next Page
Loading...
