Tenways CGO800S - Page 7

Open the seat post clamp, adjust the saddle cushion to a suitable
height, and then lock the clamp.
Distinguish between the front reector and the rear one. The
rear reector is red, while the front one is white.
The height of the seat post cannot exceed the marked safety line.
(1) (1)
(2)
Use the Phillips head screwdriver to install the rear reector
to the seat post and the front one to the handlebar.
Adjust the height of the saddle cushion.
09
10
Install the reectors.
Phillips Head
Screwdriver
Front
Reector
Rear
Reector
12 13