Teradek Wave - Recording; Recording Process; Recording Considerations

CONNECT VIA USB MODEM
1
To verify that Wave is connected, tap the gear icon or swipe right on the display
to enter the System Settings menu, then tap Wired to verify that Ethernet is set to
DHCP and to reveal Wave’s IP address. To access the web UI: Enter the network’s
IP address in your web browser’s navigation bar.
Plug an Ethernet cable from the Wave’s Ethernet port to an Ethernet switch
or router.
CONNECT VIA ETHERNET
1
2
Tap the gear icon or swipe right on the display to enter the System Settings menu,
then tap Modem to verify it is connected.
Insert a compatible 3G/4G/5G USB modem into slot 1 or 2.
13
2
3
To access the web UI: Connect your computer to Wave’s AP network (see page 4),
then enter the default IP address 172.16.1.1 in the navigation bar.