Working Operation5
56/112 TL160
Operating Manual 12.9.08 Version 1.0
5.2.2 Assembly of work attachments
Procedure for changing directly mounted work at-
tachments
• Lower the work attachment onto the ground and
position so that it cannot tilt.
• Remove the pin of the linkage and the pin of the lift
frame.
• Move the lift frame out of the work attachment and
install a new tool.
Attention
• Ensure that the bearings of the lift frame,
work attachment and quick-mount hitch
are free from dirt.
• Before disconnecting hydraulic connec-
tions, the system must be released from
pressure.
Attention
• In the event of a hydraulically operated at-
tachment, first of all the hydraulic connec-
tion must be disconnected (system must
be without pressure).
To Next Page
Loading...
