TES TES-593R - 4-5-4 Setting the Calibration Factor (CAL)

19
When the meter is normally turned on, the alarm set limit value
will display for 2 seconds.
2
X
Y
Z
1. Press key to turn off the meter.
2. Press and hold on key, then press key to turn on
the meter to enter the alarm setting mode, the “mW/m
2
” unit
is flashing displayed.
3. Press ⊳ and  keys to select the desired setting unit.
4. Press key to enter the alarm value setting mode, the
one of four digit is flashing displayed.
5. Press “⊳” keys to select the desired setting value.
6. Press key to store the new setting value and exit.
4-5-4 Setting the calibration factor (CAL)
Hold-on
Power off
+