EasyManua.ls Logo

Tesla MODEL Y - Page 162

Tesla MODEL Y
226 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3. Pull the charge port's release cable
downwards to unlatch the charge cable.
Note: The release cable may be recessed
within the opening of the trim.
4. Pull the charge cable from the charge
port.
Caution: The release cable is designed for
use only in situations where the charge
cable cannot be released from the charge
port using the usual methods. Continuous
use may result in damage to the release
cable or charging equipment.
Warning: Do not perform this procedure
while your vehicle is charging or if any
orange high voltage conductors are
exposed. Failure to follow these
instructions can result in electric shock
and serious injury or damage to the
vehicle. If you have any uncertainty as to
how to safely perform this procedure,
contact your closest Service Center.
Warning: Do not attempt to remove the
charge cable while simultaneously pulling
the release cable. Always pull the release
cable before attempting to remove the
charge cable from the charge port.
Failure to follow these instructions can
result in electric shock and serious injury.
Charge Port Light
WHITE: The charge port door is open.
Model Y is ready to charge and the
connector is not inserted, or the charge
port latch is unlocked and the connector is
ready to be removed.
Note: In cold ambient temperatures below
41° F (5° C), the charge port remains
unlocked whenever the vehicle is not
charging. In these situations, the charge
port light is white.
BLUE: Model Y detects that a connector
has been plugged in.
BLINKING BLUE: Model Y is
communicating with the connector. Either
Model Y is preparing to charge, or a
charging session is scheduled to begin at
a specified future time.
BLINKING GREEN: Charging is in progress.
As Model Y approaches a full charge, the
frequency of the blinking slows.
SOLID GREEN: Charging is complete.
SOLID AMBER: The connector is not fully
plugged in. Realign the connector to the
charge port and insert fully.
BLINKING AMBER: Model Y is charging at
a reduced current (AC charging only).
RED: A fault is detected and charging has
stopped. Check the touchscreen for a fault
message.
Charging Instructions
Charging 161

Table of Contents

Related product manuals