While this alert is present, the deceleration
rate of the vehicle due to regenerative braking
will be reduced and more brake pedal
application will be required to slow the vehicle
(similar to what is needed in a gas-powered,
non-electric, vehicle).
This alert is expected under the following
conditions:
• Battery is near full charge:
• Regenerative braking is reduced when
the battery is at 95% charge or higher.
• Battery is cold:
• The battery may not be warm enough
for full regenerative braking
performance (possibly at the
beginning of a drive).
• In extremely cold climates, this alert
may remain present indefinitely and
regenerative braking may remain
reduced, as driving the vehicle may
not warm the battery enough to fully
restore performance.
Typically, driving will clear this alert because it
will reduce the battery charge level below 95%
and suciently warm the battery.
This is a completely normal part of vehicle
operation and should not cause alarm. The
notice on the screen is for your information
only.
For more information on regenerative braking,
see the Regenerative Braking section in the
Owner’s Manual. Regenerative Braking.
(UMC_a017)Charging speed
reducedHigh temperature detected
by Mobile Connector
High temperature detected by Mobile
Connector alerts indicate the outlet used to
charge is becoming too warm, so charging has
been slowed to protect the outlet.
This is not typically an issue with your vehicle
or your Mobile Connector, but rather an issue
with the outlet. A warm outlet may be caused
by a plug that is not fully inserted, a loose
building wiring connection to the outlet, or an
outlet that is beginning to wear out.
To regain normal charge speed, make sure
your adapter is fully plugged into the outlet. If
charging speed does not return to normal,
contact an electrician to inspect the outlet
and building wiring connections to the outlet
and complete any repairs needed.
If the outlet is worn, it should be replaced with
a high-quality outlet. Consider upgrading to a
Tesla Wall Connector for greater convenience
and highest charging speed.
(UMC_w008)Charging stoppedHigh
temperature detected by Mobile
Connector
High temperature detected by Mobile
Connector alerts indicate the outlet used to
charge is becoming too warm, so charging has
stopped to protect the outlet.
This is not typically an issue with your vehicle
or your Mobile Connector, but rather an issue
with the outlet. A warm outlet may be caused
by a plug that is not fully inserted, a loose
building wiring connection to the outlet, or an
outlet that is beginning to wear out.
To regain normal charge operation, make sure
your adapter is fully plugged into the outlet. If
charging speed does not return to normal,
contact an electrician to inspect the outlet
and building wiring connections to the outlet
and complete any repairs needed.
If the outlet is worn, it should be replaced with
a high-quality outlet. Consider upgrading to a
Tesla Wall Connector for greater convenience
and highest charging speed.
Troubleshooting Alerts
Consumer Information 217
To Next Page
Loading...
