4. Commissioning
This chapter describes the steps required to commission the product.
Inserting
batteries/rechargeable
batteries
and
a
radio
module
(accessory
part):
1 Undo the two screws on the rear of the instrument and lift off the battery
compartment cover.
2 Insert batteries/rechargeable batteries (3x mignon) into the battery
compartment. Observe the polarity!
3 Push the radio module (accessory part) into the radio module
compartment until it engages in place. Note the guide groove.
4 Replace the battery compartment cover, press down and secure by
tightening the two screws.
4. Commissioning 9
deenfresitptsvnl????
To Next Page
Loading...
