6 Using the product
23
4. Adjust the flashing number with [▲]
and [▼] and press [◄]
and [►] to go to the next number.
5. Confirm the input with [OK].
6. Choose the memory location.
7. Press [Save].
6.2.7. Pressure/Compressor
✓ Oil pressure probe connected to the upper Mini-DIN connection.
1. Press [Mode].
2. Select [Pressure/Compressor].
- The measurement values for low pressure side and oil pressure
(p
ext
) are displayed.
6.2.8. Current
✓ Clamp probe connected to the upper Mini-DIN connection.
1. Press [Mode].
2. Select [Current].
- The measurement value of the current measurement is
displayed.
6.2.9. Efficiency calculation
1. Press [Mode].
2. Select [Efficiency calc.].
- The efficiency calculation is displayed.
See also Basis of calculation COP, page 30.
6.3. Saving measurement values
The testo 570 is able to record a series measurement of up to
999 h.
The testo 570 is able to save up to:
• 10000 single measurements or
• 50 series measurements in a measuring cycle of 2 seconds
over a maximum period of 100 hours.
Depending on the selected measuring cycle, only a certain
measurement period can be set. Here is an overview of the
possible settings.
Shop for Data Logging products online at: www.DataLoggerStore.com 1.877.766.5412
To Next Page
Loading...
