32
The following sub-menus should be checked or set before storing:
PROGRAMME - START
- Lower limit/Upper limit
A probe must be connected via which the program can be started
. Auto-OFF to “OFF”. Input the required limit values.
Note: Do not switch off the instrument after programming
otherwise the starting criterium cannot be monitored.
- Manual
Start the program on location by pressing the function button.
The button is automatically allocated with “Start”.
- Date/Time
Does the program start at the specified time ?
(With measuring cycles greater than 2 min the instrument switches
off if Auto-Off was activated → power-save mode. It is activated to
start measuring).
PROGRAMME - CYCLE TIME: determines the interval between two measurements. The time
unit can be selected via the function buttons: s, min or h.
Note: The starting time must lie in the future.
Automatic storing
Note:
Some probes need a certain “Waking up” time. It is not possible to measure during this
time. A counter going backwards is blended in. This is taken into consideration when
automatic storage out of the sleep mode takes place (Auto OFF).
Probes which have to be zeroised after being switched on should be used for longterm
logging in continuous operation, mode Auto-OFF (OFF).
To Next Page
Loading...
