Shenzhen TestPad Electronic Co., Ltd. http://www.test-pad.com
10
If the ID of a MOTO mobile phone needs be tested separately, simply connect the terminal of the
ID to the ID terminal, and use a separate wire to connect the P- of the battery to the P- terminal of
the tester.
If the capacity of Nickel-Metal hydride battery or Nickel-Cadmium battery needs be tested or
these two types of batteries need be charged, our delivery-attached temperature sensor is required.
Place the temperature sensor close to the surface of the battery to be tested, and connect the
temperature sensor to the P- and R2 of the tester. Then the tester can monitor the temperature of
the battery, thus to better judge the condition of the battery and ensure safe charge.
To Next Page
Loading...