Shenzhen TestPad Electronic Co., Ltd. http://www.test-pad.com
11
Main Menus
After the start-up interface of the tester is displayed, the main interface appears, as shown below.
If there are more than four options, the excessive options will be displayed in the second interface,
as shown below.
If there are more than eight options, the excessive options will be displayed in the third interface,
as shown below.
Description of the above options:
1. Battery static parameter test
2. Battery capacity test
3. Battery charge-only function
4. Battery discharge-only function
5. Program-controlled DC power
->1. Static Test
2. Capacity Test
3. Battery charge
4. Battery discharge
->5. Program DC Power
6. Program E-load
7. VOL and IMP
8. Enter Calibration
->9. Read DS2502
To Next Page
Loading...