TestPad BTS-2002H - Capacity Test; Parameter Setup for Li-ion; Parameter Setup for NiCd; Test Process Flow

Shenzhen TestPad Electronic Co., Ltd. http://www.test-pad.com
20
Capacity Test
Select Capacity Test from the main menu to set the battery capacity parameters, as shown
below.
Selecting whether to test over-charge/over-discharge
1. Items 1~3 are the same as those on the static parameter setting interface. Refer to Static Test.
2.
Lion
OC/OD
:
For
Li-ion
battery,
select
YES
to
enable
the
over-charge/over-discharge
test.
..................... Selecting whether to discharge
..................... Nickel-Cadmium battery before charging it
3.
If
the
current
battery
type
is
Nickel-Cadmium
battery,
the
fourth
menu
item
is
“
4.NiCd
PRE_DIS: NO”. Set whether to discharge the Nickel-Cadmium battery before charging it so
as to eliminate the memory effect of the battery and ensure accurate measurement.
4.
If
the
current
battery
type
is
Nickel-Metal
hydride
battery
or
SLA,
the
fourth
menu
item
is
unavailable.
After you pressing ENTER, the tester follows the process below to test the capacity of the battery.
Pre-discharge (if the current battery type is Nickel-Cadmium battery and pre-discharge is enabled)
→
→→
→ Fully charge the battery
Over-current test (if the current battery type is Li-ion battery and over-charge test is enabled)
→
→→
→ Wait 100 seconds
Fully discharge
→
→→
→
Over-discharge test (if the current battery type is Li-ion battery and
over-discharge test is enabled)
→
→→
→
End
->1. Pack type: Lion
2. Pack Vol: 3.6V
3. Pack Cap: 500mAH
4.
Lion
OC/OD:
NO
->1. Pack type: NiCd
2. Pack Vol: 3.6V
3. Pack Cap: 500mAH
4. NiCd PRE_DIS: NO