18
7. PRE
-USE PREPARATION
ATLAS X (MADE IN EUROPE)
7.1 SHIPPING CONDITIONS
• The wind turbine system is shipped disassembled.
• Refer to the contract documentation for the scope of supply.
WARNING: Danger to life due to operation in non-approved wind classes!
The wind turbine system may only be operated at Class III wind sites.
7.2 PRE-REQS AT THE PLACE OF USE
• Certain pre-requisites are to be followed at the place of use.
• Specifications related to footprint, minimum clearances and installation
conditions are provided, which needs to be taken care.
7.2.1 PERMISSIBLE WIND CLASS, FOOTPRINT,
AND MINIMUM CLEARANCES:
• For information on local wind classes, please contact the responsible au-
thorities or your nearest meteorological office.
• The place of use must be free of obstacles; alternatively, the wind turbine
must be erected with a sufficient height (refer to Fig.). As this is specifically
for home use, the location on top of the house or terrace should be good for
proper functioning of the turbine.
NOTE: When choosing the place of use, make sure
adequate room is available to tilt the tower and blades
To Next Page
Loading...
