Tesup ATLAS2.0 - Safety Information; Modifications or Changes by the User; Residual Risks; Personnel Requirements

ATLAS 2.0 (MADE IN EUROPE)
~ 17 ~
TESUP
6.1 MODIFICATIONS OR CHANGES BY THE USER:
▪ The wind turbine system is in conformity with the European Machinery Directive
2006/42/EC provided only original ATLAS 2.0 components are used and subject to
proper erection. The use of components from other manufacturers as well as
modifications or changes to the wind turbine system by the user are prohibited and
could render the declaration of conformity invalid!
6.2 RESIDUAL RISKS:
▪ Any residual risks which arise because of operation or maintenance are described in
the relevant sections of these instructions.
6.3 PERSONNEL REQUIREMENTS:
▪ All work on the wind turbine system must be carried out by authorised persons! Such
persons must be familiar with the safety devices and regulations prior to carrying out
the work.
▪ Authorised persons are defined as follows:
Operating mode
Necessary qualifications
Erection
Suitably trained persons
Normal operation
Trained personnel
Cleaning
Trained personnel
Maintenance
Suitably trained persons
Repair
Manufacturer
PERSONNEL REQUIREMENT TABLE
6.4 IMPORTANT SAFETY INSTRUCTIONS
▪ Properly torque all fasteners.
▪ Use grounding techniques as established by the NEC.
▪ Install turbine in accordance with this manual and local and national building codes. Failure to
comply may affect and possibly void your warranty.
▪ Properly complete the Warranty Registration Card
▪ Observe wire size and fuse recommendations listed in the Wiring Section of this manual.
6. SAFETY INFORMATION
WARNING: Rotating blades are a serious mechanical hazard. Install wind turbines
so no one can come in contact with blades.