Tesup ATLAS2.0 - Pre-Use Preparation; Shipping Conditions; Prerequisites at the Place of Use; Permissible Wind Class, Footprint, and Clearances

ATLAS 2.0 (MADE IN EUROPE)
~ 18 ~
TESUP
7.1 SHIPPING CONDITIONS:
▪ The wind turbine system is shipped disassembled.
▪ Refer to the contract documentation for the scope of supply.
7.2 PRE-REQS AT THE PLACE OF USE:
7.2.1 Permissible wind class, footprint, and minimum clearances:
▪ For information on local wind classes, please contact the responsible authorities or
your nearest meteorological office.
▪ The place of use must be free of obstacles; alternatively, the wind turbine must be
erected with a sufficient height (refer to Fig.). As this is specifically for home use, the
location on top of the house or terrace should be good for proper functioning of the
turbine.
7. PRE-USE PREPARATION
WARNING: Danger to life due to operation in non-approved wind classes!
The wind turbine system may only be operated at Class III wind sites.
NOTE: When choosing the place of use, make sure
adequate room is available to tilt the tower and blades
if necessary.