Tesvor Robot Vacuum - Troubleshooting and Replaceable Parts; Alarm Prompts and Solutions

6.1 Alarm Prompt
Message
Failure Cause
Solution
Dust container not installed
Dust Container was taken out and
Pack the filter back into the
not installed
dust container and press the
cleaning key
Please check whether the
The wheels holder is blocked
Check whether the wheel has
wheels are jammed
up
been wound and clean it up
Please check whether the front
The front holder is stuck
Check if the front holder can
is jammed
rebound itself normally
Low battery,Please
Less than 20% power left
The machine automatically
charge this robot
enters the recharge mode
Please check if the brush is
Brush edge issues
Check if the brush is entangled
wound or jammed
by wire/cable and clean up
Please move the machine to
The machine failed to recover
Move the vacuum to the
the open area and press the
spacious area and press the
cleaning key for cleaning
cleaning button