1: Overview of Calculator Operations 7
Procedure: Changing the Number of Decimal Places
쐃
Press
&
|
.
DEC=
is displayed with the current
decimal-place setting.
쐇
Enter the number of decimal places to be displayed (0
through 9) and press
!
. To specify a floating-decimal
format, enter 9.
쐋
Choose one of the following to continue:
<
To continue setting formats, press
#
.
<
To return to the standard-calculator mode, press
&
U
.
<
To access a worksheet, press the appropriate worksheet
key or key sequence.
Angle Unit Format
You can enter and display angle values in either degrees or
radians. You can specify which method you require.
The default setting for angle units is degrees. There is no
display indicator for this setting. However, if you specify
radians, the
RAD
indicator is displayed in the upper right-hand
corner of the display.
Procedure: Changing the Angle Unit Format
쐃
If necessary, press
&
|
#
.
The most recently selected angle-units format is displayed,
either
DEG
or
RAD
.
쐇
Press
&
V
repeatedly to set either
DEG
or
RAD
.
쐋
Choose one of the following to continue:
<
To continue setting formats, press
#
or
"
.
<
To return to the standard-calculator mode, press
&
U
.
<
To access a worksheet, press the appropriate worksheet
key or key sequence.
To Next Page
Loading...
