www.ti.com
Commands
159
SWRU271H–October 2010–Revised April 2019
Submit Documentation Feedback
Copyright © 2010–2019, Texas Instruments Incorporated
HCI Extension API
hciStatus_t HCI_EXT_SetTxPowerCmd( uint8 txPower )
This command sets the RF transmitter output power. The default system value for
this feature is 0 dBm.
Parameters txPower– Device's transmit power, one of the following:
Corresponding Events: HCI_VendorSpecifcCommandCompleteEvent:
• HCI_EXT_TX_POWER_MINUS_21_DBM
• HCI_EXT_TX_POWER_MINUS_18_DBM
• HCI_EXT_TX_POWER_MINUS_15_DBM
• HCI_EXT_TX_POWER_MINUS_12_DBM
• HCI_EXT_TX_POWER_MINUS_9_DBM
• HCI_EXT_TX_POWER_MINUS_6_DBM
• HCI_EXT_TX_POWER_MINUS_3_DBM
• HCI_EXT_TX_POWER_0_DBM
• HCI_EXT_TX_POWER_1_DBM
• HCI_EXT_TX_POWER_2_DBM
• HCI_EXT_TX_POWER_3_DBM
• HCI_EXT_TX_POWER_4_DBM
• HCI_EXT_TX_POWER_5_DBM
To Next Page
Loading...
Need help?
General
