Texas Instruments CC35 E Series - Specification; Device Information

1.3 Specification
The LP-EM-CC35X1 is a board designed to enable rapid and easy software and hardware development for the
CC35xxE device. The block diagram for the LP-EM-CC35X1 is shown in Figure 1-1.
CC3551ENJARSHR
Wi-Fi 6 and Bluetooth® low
energy Wireless MCU
2 x 20 pin
LaunchPad
connector
I2C
Temp Sensor
Accelerometer
5V
5V
40-MHz
XTAL
32.768-kHz
XTAL
20 pin LP-XDS110
connector
Filtering
QSPI FLASH
5V
Dual Rail LDO
(1.8V & 3.3V)
VCC
VCC
Push
Buttons
nReset
3.3V power
1.8V power
LEDs
User LEDs
RGB
nReset
SPI x 2
UART x 2
I2C x 2
ADC x 4
I2S/PDM
SD Card Slot
QSPI PSRAM
DCAN
GPT/PWM
GPIO
nReset
SWD
UART
RF
QSPI
U.FL/SMA
SD/MMC
Antenna
Figure 1-1. LP-EM-CC35X1 Block Diagram
1.4 Device Information
The purpose of the LP-EM-CC35X1 is to showcase the hardware and software capabilities of the CC35xxE
device. The other components on the board are populated for testing and support of this main device.
www.ti.com Evaluation Module Overview
SWRU629 – SEPTEMBER 2024
Submit Document Feedback
CC35xxE LaunchPad™ Development Kit for SimpleLink™ Wi-Fi 6 and
Bluetooth® Low Energy Wireless MCU
3
Copyright © 2024 Texas Instruments Incorporated