Texas Instruments Extensa 60x Series - Removing;Replacing the Display Assembly

6-16 Field Service
6.5.9 Removing/Replacing the Display Assembly
Use the following procedure to remove/replace the display assembly:
1. Remove the battery and AC adapter as described in Paragraph 6.5.1.
2. Refer to Figure 6-13 and remove the two screws that secure the display cable
to the Motherboard assembly. Then unplug display cable J19
.
Figure 6-13 Unplugging the Display Cable
3. Remove the four display hinge screws (Figure 6-14) and separate the Display
Assembly from the Base Assembly.
Remove the two screws
holding the display cable
to the motherboard