Field Service 6-17
4. Installation is the reverse of Steps 1 through 3.
Figure 6-14 Removing the Display Hinge Screws
6.5.10 Removing/Replacing the Top Cover
Use the following procedure to detach the top cover from the Base Assembly:
1. Separate the Display Assembly from the Base Assembly as described in
Paragraph 6.5.9.
2. Remove the two screws that secure the heat sink to the base assembly.
3. Remove the two screws on the top and ten screws on the bottom that hold
the top cover in place; unsnap and remove the top cover (refer to Figure 6-15).
Remove four screws securing
display assembly to the
base assembly
To Next Page
Loading...
