Field Service 6-9
6.5.4 Removing/Replacing the Keyboard Assembly
The procedure for removing and replacing the keyboard assembly is as follows:
1. Turn off the computer; disconnect the AC power adapter (if it is attached),
and remove the battery pack as described in Paragraph 6.5.1.
2. Press the Cover Release Latch and open the notebook to a full 180 degree
position as shown in Figure 6-6.
3. Slide each of the two display hinge covers out and pull upward to remove
from the notebook.
Figure 6-6 Removing the Display Hinge Covers
4. Pull up on the keyboard as shown in Figure 6-7 and disconnect the Touchpad
cable connector J0104.
Slide hinge cover
out and then pull up
Slide hinge cover
out and then pull up
Open Notebook
to 180 degree position
To Next Page
Loading...
