6-30 Field Service
4. Replacement is the reverse of Steps 1 through 3.
Figure 6-26 Removing/Replacing the PCMCIA Module
6.5.21 Removing/Replacing the Touchpad Assembly
Use the following procedure to remove/replace the Touchpad Assembly:
1. Remove the Keyboard Assembly as described in Paragraph 6.5.4.
2. Remove the Top Cover Assembly as described in Paragraph 6.5.11.
3. Refer to Figure 6-28; remove the center screw and disconnect the Touchpad
cable J1.
4. Remove the Touchpad main sensor and connector unit.
5. Remove the two side screws and remove the metal plate.
To Next Page
Loading...
