Texas Instruments Extensa 60x Series - Page 116

6-32 Field Service
1. Remove the AC adapter and Battery Pack as described in Paragraph 6.5.1.
2. Remove the round LCD bumpers at the top of the display (refer to Figure 6-29).
3. Remove the left and right screws near the display hinges (note that the screw
covers are not identical).
4. Remove four screws on the Display Bezel (Figure 6-29).
5. Pull out and remove the Display Bezel.
Figure 6-29 Display Unit Disassembly
1
2
3
4
5
6
7
Removing the Display Cable
Assembly
Removing the
Inverter Boards
Removing
LCD Screws
Removing Hinge
Cable Cover
Removing the
Bezel
RemovingScrews
and Bumpers
Removing Bezel
Screws