Programming MSP430 Devices With the GUI
2-8
Table 2−2.Error Messages
Error Type Error Message
Communication Communication failed!
Communication Adapter not connected!
Communication Synchronization with adapter failed!
Communication The present adapter is not an MSP-PRGS430!
Communication Missing setting of V
CC
!
MSP430 Target not connected!
MSP430 Wrong JTAG version!
MSP430 PUC failed!
MSP430 Wrong target!
MSP430 Target fuse is blown!
MSP430 Blown fuse failed!
MSP430 Supply voltage to low!
MSP430 Fuse not released for this device!
Setting Unknown target!
Setting No target selected!
Setting Wrong V
CC
selected!
Setting Wrong baud rate!
Setting Communication port error!
Setting The selected range is invalid!
Setting Wrong argument!
Setting Error at target address (during erase check or verify)
Setting Unknown command line option
Setting Command line option out of valid range
System DEVICE.CFG corrupted
System General error!
System File type could not be detected!
System Unexpected end of file!
System PROJECT.INI corrupted!
System Filename mismatch
System Error in DEVICE.CFG
Windows Error during file I/O
To Next Page
Loading...
Need help?
General
