PRGS430.DLL—Description
2-23
Operation
2.4.1 Return Values/Error Codes From PRGS430.DLL
Status Return Value Comment
OK 0
SUCCESS −1 Operation OK
ERR_COMMUNICATION −2 Communication error (SSP)
ERR_TARGET_NOT_CONNECTED −3 No target connected
ERR_SPA430_NOT_CONNECTED −4 No SPA430 connected
ERR_WRONG_JTAG_VERSION −5 JTAG version above 3
ERR_PUC_FAILED −6 PUC did not succeed
ERR_SPA430_SYNC_FAILED −7 Could not sync SPA430
ERR_NO_SPA430 −8 Adapter is not SPA430
ERR_UNKNOWN_TARGET −9 Target type unknown
ERR_WRONG_TARGET −10 Target type does not match
ERR_NO_TARGET_SELECTED −11 No target selected (missing SetDeviceType() call)
ERR_TARGET_FUSE_BLOWN −12 No target access because of blown fuse
ERR_BLOW_FUSE_FAILED −13 Blown-fuse command failed
ERR_VCC_NOT_SET −14 No V
CC
selected (missing SetVolt() call)
ERR_WRONG_VCC −15 V
CC
out of allowed range
ERR_WRONG_BAUDRATE −16 Invalid baud rate
ERR_COMPORT −17 Error accessing the communications port
ERR_DEVICE_CFG −18 Device.cfg corrupted
ERR_GENERAL −19 General error (should not occur!)
ERR_RANGE −20 Wrong range specified
ERR_ARGUMENT −21 Wrong argument
ERR_FILE_IO −22 Error during file I/O
ERR_FILE_DETECT −23 File type could not be detected
ERR_FILE_END −24 Unexpected end of file
ERR_PROJECT_INI −25 Error reading {project}.ini
ERR_VCC_BELOW_VCCMINPROG −26 V
CC
to low for selected function
ERR_FUSE_NOT_RELEASED −27 Fuse not release for this device
STATUS_CONNECTSPA 1 Connecting to SPA430
STATUS_CONNECTTARGET 3 Connecting to target
STATUS_RELEASETARGET 5 Releasing target
STATUS_RELEASESPA 7 Releasing SPA430
STATUS_RESETTARGET 9 Resetting target
STATUS_ERASE 11 Erasing target
STATUS_ERASECHECK 13 Erase checking target
STATUS_PATTERNCHECK 15 Pattern checking target
STATUS_VERIFY 17 Verifying target
STATUS_PROGRAM 19 Programming target
STATUS_READOUT 21 Reading out target
STATUS_BLOWFUSE 23 Blowing fuse
ERR_READOUT_LOCKED −28 Read out prohibited
To Next Page
Loading...
Need help?
General
