SERVICE INFORMATION
PRINTING PAPER REPLACEMENT
A roll of thermal printing paper was included with your Tl-5015 calculator.
When you near the end of the roll, a continuous stripe will appear to the right
of
the printout to indicate that there are approximately ten feet of paper left
in
the roll.
As
you continue operating the calculator, check to make sure that
sufficient printing paper remains to complete your calculations.
When
replacing
the
paper
in
your
Tl-5015,
use
only
Texas
Instruments
TP-20225
or
TP 27225
thermal
printing
paper.
Other
thermal
papers
may
damage
your
calculator
and
void
the
warranty. New paper may be
obtained at the store where your Tl-5015 was purchased.
If your local store
is temporarily out of paper, you may order it from Texas Instruments Service
Facility,
P.O.
Box 53, Lubbock, Texas 79408.
Follow these steps to install new paper:
1. Lift the old roll
of
paper from the calculator and cut or tear the paper to
separate the end of the roll from the paper remaining in the printing
mechanism.
STRIPE
23
To Next Page
Loading...
Need help?
General
