Introduction to TI-SmartView™ CE Software
The TI-SmartView™ CE software allows you to display a TI graphing calculator for your
entire classroom. Two workspaces are included to help enhance your classroom
presentations.
Calculator Emulator Workspace
Allows you to:
• Display a Full Emulator View or a Keypad with Large
Display Screen View. With optional views to open or
close.
• Key Press History
– Displays images of keys pressed so students can
follow along with the keys pressed.
• View
3
™
– Teacher controlled update of up to three
additional emulated screens such as Graph, Table
and Equation for multiple representations.
• Calculate and Graph
– Same experience as on physical graphing
calculator.
• Drag and Drop any emulated screen to your class
presentation software.**
– Build out your lessons with screens created during
your class.
• Press emulator keys using a Remote Keypad!
– Run SmartPad™ CE App*** on your TI-84 Plus CE
connected to the computer with your USB cable.
When the TI-SmartView™ CE window is in focus
on your computer, your calculator becomes a
Remote Keypad.
• Launch a separate Screen Capture Window
– Capture and save emulator screens as computer
files similar to TI Connect™ CE Screen Capture
which captures screens from the graphing
calculator.
**Software such as Microsoft™ Office or other presentation software supported.
***SmartPad™ CE App for TI-84 Plus CE comes pre-loaded on the calculator. If not on
your TI-84 Plus CE, SmartPad CE App is also available to load to your calculator at
education.ti.com/84ceupdate.
Note: The Large Display Screen is not touch enabled. Use emulator keys as on the
calculator.
Introduction to TI-SmartView™ CE Software 2
To Next Page
Need help?
General
