General Precautions for the TI-Innovator™ Hub
TI-Innovator™Hub
• Do not expose the Hub to temperatures above 140˚F (60˚C).
• Do not disassemble or mistreat the Hub.
• Do not chain together multiple Hubs through the I/O ports or the Breadboard
Connector.
• Use only the USB cables provided with the Hub.
• Use only the TI provided power supplies:
- TIWallCharger included with the TI-Innovator™Hub
- Optional External Battery Pack
- 4AA battery holder included in the TI-Innovator™ Breadboard Pack
• Ensure that the components receiving power from the Hub do not exceed the Hub's
1-amp power limit.
• Avoid using the Hub to control AC electricity.
Breadboard Connector on the Hub
• Do not insert the leads of LEDs and other components directly into the Hub’s
Breadboard Connector. Assemble the components on the breadboard and use the
provided jumper cables to connect the breadboard to the Hub.
• Do not connect the 5V receptacle pin on the Hub's Breadboard Connector to any of
the other pins, especially the ground pins. Doing so could damage the Hub.
• Connecting the top row of receptacle pins (BB1-10) to the bottom row (grounding
and power pins) is not recommended.
• No pin on the Hub's Breadboard Connector can sink or source greater than 4 mA.
7
To Next Page
Loading...
Need help?
General