Configuring Handhelds 63
Configuring Handhelds
This chapter provides information needed to:
• Maintain batteries used in the handheld.
• Change the default settings.
• Attach a wireless module when the handheld is used in the classroom.
Checking Battery Status
To check the status of the TI-Nspire™ Rechargeable Battery in a
handheld:
1. Press
c.
The
Home screen opens.
2. Press 54 (Settings > Status).
The
Handheld Status dialog box opens.
3. Click
OK or press · to close the window.
Note: From an open document, press
~74 (~ > Settings &
Status > Status
).
Recharging the Handheld
To recharge the TI-Nspire™ Rechargeable Battery in a handheld, connect
it to any of the following power sources:
• A standard USB cable connected to a computer
• A TI USB wall charger (sold separately)
Battery status is
shown here.
To Next Page
Loading...
