uDMA Controller
Description:
This function sets the base address of the channel control table. This table resides in system
memory and holds control information for each uDMA channel. The table must be aligned on
a 1024 byte boundary. The base address must be set before any of the channel functions can
be used.
The size of the channel control table depends on the number of uDMA channels, and which
transfer modes are used. Refer to the introductory text and the microcontroller data sheet for
more information about the channel control table.
Returns:
None.
23.2.1.19 ROM_uDMADisable
Disables the uDMA controller for use.
Prototype:
void
ROM_uDMADisable(void)
ROM Location:
ROM_APITABLE is an array of pointers located at 0x0100.0010.
ROM_UDMATABLE is an array of pointers located at ROM_APITABLE[17].
ROM_uDMADisable is a function pointer located at ROM_UDMATABLE[2].
Description:
This function disables the uDMA controller. Once disabled, the uDMA controller will not operate
until re-enabled with ROM_uDMAEnable().
Returns:
None.
23.2.1.20 ROM_uDMAEnable
Enables the uDMA controller for use.
Prototype:
void
ROM_uDMAEnable(void)
ROM Location:
ROM_APITABLE is an array of pointers located at 0x0100.0010.
ROM_UDMATABLE is an array of pointers located at ROM_APITABLE[17].
ROM_uDMAEnable is a function pointer located at ROM_UDMATABLE[1].
Description:
This function enables the uDMA controller. The uDMA controller must be enabled before it can
be configured and used.
Returns:
None.
April 8, 2013 293
To Next Page
Loading...
Need help?
General
