Texas 4675 W - User Manual

Questions and Answers

V
vgonzalesAug 9, 2025
Why Texas 4675 W machine will not start when the start cord is pulled?
- L
  Lydia WilliamsAug 9, 2025
  Several factors can prevent your Texas Lawn Mower from starting when you pull the cord. Make sure that the engine brake handle is activated. The brake cable might need adjustment, following the instructions in the manual. High grass can also be the reason, so move the mower to a clear area or tip the machine to start and set the height adjustment in the highest position. Ensure you prime the engine by pushing the primer 1-3 times before starting. Also, check the fuel tank and refill if necessary. If the gasoline is old (more than 3 months), empty the tank and carburetor and refill with fresh gasoline.
G
gallagherjenniferAug 14, 2025
What to do if my Texas 4675 W engine runs irregularly?
- J
  Jesse BrownAug 14, 2025
  If your Texas Lawn Mower engine runs irregularly or its performance declines, check the following: Ensure the spark plug cap is firmly attached and that the spark plug is clean and undamaged, following the instructions in the manual. Inspect and adjust the spark plug gap, following the instructions in the manual. Examine the air filter for dirt and clean it, following the instructions in the manual. If fuel evaporation in the carburetor is suspected, wait a few minutes before restarting. Also, tighten the throttle cable, following the instructions in the manual, and clean the carburetor.
D
David CarlsonAug 19, 2025
What to do if my Texas 4675 W Lawn Mower has no ignition spark?
- S
  Sheena AndersonSep 12, 2025
  If your Texas Lawn Mower lacks an ignition spark, start by checking that the spark plug cap is firmly attached. Inspect the spark plug for dampness or dirt, following the instructions in the manual. Verify and adjust the spark plug gap, following the instructions in the manual, or replace the spark plug if necessary. Also, check the air filter for dirt and clean it, following the instructions in the manual.
M
martineznathanAug 25, 2025
What to do if the start cable is very tight on my Texas Lawn Mower?
- M
  mcoxAug 25, 2025
  If the start cable on your Texas Lawn Mower is very tight, make sure the brake handle is activated before pulling the cord. Also, if the mower is in high grass, move it to an area with shorter grass and try again. Setting the height adjustment to the highest position can also help by lifting the blade free of the grass.
S
Scott SchneiderAug 29, 2025
Why Texas Lawn Mower machine does not stop after 5 seconds?
- M
  Mrs. Carrie ColemanAug 29, 2025
  If your Texas Lawn Mower doesn't stop after 5 seconds, it's likely that the engine brake cable is running too tightly. Check and adjust the engine brake cable, following the instructions in the manual.
E
Erin BrooksSep 3, 2025
What to do if the back wheels are not pulling on my Texas 4675 W?
- G
  George BradleySep 3, 2025
  If the back wheels of your Texas Lawn Mower aren't pulling or are pulling very little, the clutch cable may be too tight or too loose. Adjust the clutch cable, following the instructions in the manual. Also, the ratchets in the rear wheels might be worn, in which case they should be replaced.

Texas 4675 W Specifications

General

Cutting Width	46 cm
Engine Type	4-stroke
Starter	Recoil
Collection Box Capacity	50 L
Mulching	Yes
Side Discharge	Yes
Deck Material	Steel
Cutting Height Adjustment	Central
Wheel Size	7 inches front