What to do if my Texas 4210 does not stop after 5 seconds?
If your Texas Lawn Mower doesn't stop after 5 seconds, the engine brake cable might be running too tightly. In this case, you should check and adjust the engine brake cable.
What to do if the air filter of my Texas Lawn Mower is dirty?
If the air filter of your Texas Lawn Mower is dirty or defective, check it for dirt and clean it, following the instructions in the manual.
What to do if my Texas 4210 Lawn Mower spark plug is damp or dirty?
If the spark plug of your Texas Lawn Mower is damp or dirty, check that there is no dirt on it, following the instructions in the manual.
What to do if my Texas Lawn Mower has gasoline that is more than 3 months old?
If the gasoline in your Texas Lawn Mower is more than 3 months old, empty the fuel tank and carburetor of the old gasoline, and fill it with new gasoline.
What to do if my Texas Lawn Mower brake handle is not being activated?
If the brake handle of your Texas Lawn Mower is not being activated, activate the brake handle and pull the start cord.
Why won't my Texas 4210 start, even when pulling the cord or pushing the electric start button?
There are several reasons why your Texas Lawn Mower might not be starting. Make sure you are activating the engine brake handle when starting. Check that the wires are correctly connected to the battery. The engine brake cable might need adjustment. Ensure the mower isn't standing in high grass. Prime the engine by pushing the primer 1-3 times. Verify the choke is in the correct position. Also, check the fuel tank to make sure it's not empty or that the gasoline isn't old (more than 3 months). If the gasoline is old, empty the tank and carburetor and refill with fresh gasoline.
What to do if there is evaporation of fuel in the carburetor of my Texas 4210?
If there is evaporation of fuel in the carburetor of your Texas Lawn Mower, wait a few minutes, and then try to start again.
What to do if the ratchets in the rear wheels of my Texas 4210 are worn?
If the ratchets in the rear wheels of your Texas Lawn Mower are worn, replace the ratchets.
What to do if my Texas 4210 Lawn Mower wires are not connected to battery?
If the wires of your Texas Lawn Mower are not connected to the battery, check that the wires are connected from the battery to the motor and start button.
What to do if my Texas Lawn Mower lever is in the "Choke" position?
If the lever of your Texas Lawn Mower is in the "Choke" position, set the lever in the "Run" position.
General| Number of cutting heights | 7 |
|---|---|
| Mulching function | Yes |
| Bagging Capability | Yes |
| Power source | Petrol |
| Starting system | Recoil starter |
| Drive | Self-propelled |
| Wheels rear | 10 inch |
| Cutting height | 1.25 - 3.75 inches |
To Next Page
