To Next Page
S
Shirley AndersonAug 29, 2025
What to do if my Texas 4210 is placed in high grass?
- DDouglas RamseyAug 29, 2025
If your Texas Lawn Mower is placed in high grass, move the machine away from the high grass and repeat the start procedure.
What to do if my Texas 4210 is placed in high grass?
If your Texas Lawn Mower is placed in high grass, move the machine away from the high grass and repeat the start procedure.
What to do if my Texas 4210 engine is not primed before starting?
If the engine of your Texas Lawn Mower is not primed before starting, push the primer 1-3 times before starting.
What to do if my Texas Lawn Mower brake handle is not being activated?
If the brake handle of your Texas Lawn Mower is not being activated, activate the brake handle and pull the start cord.
What to do if my Texas Lawn Mower has gasoline that is more than 3 months old?
If the gasoline in your Texas Lawn Mower is more than 3 months old, empty the fuel tank and carburetor of the old gasoline, and fill it with new gasoline.
What to do if my Texas 4210 Lawn Mower spark plug is damp or dirty?
If the spark plug of your Texas Lawn Mower is damp or dirty, check that there is no dirt on it, following the instructions in the manual.
What to do if the air filter of my Texas Lawn Mower is dirty?
If the air filter of your Texas Lawn Mower is dirty or defective, check it for dirt and clean it, following the instructions in the manual.
General| Number of cutting heights | 7 |
|---|---|
| Mulching function | Yes |
| Bagging Capability | Yes |
| Power source | Petrol |
| Starting system | Recoil starter |
| Drive | Self-propelled |
| Wheels rear | 10 inch |
| Cutting height | 1.25 - 3.75 inches |
