Premier 412/816/832 Master User Manual Operating the Alarm System
INS141-8 7
Disarming During Entry
To disarm the alarm system during entry, proceed as
follows:
T he en try to ne will s to p a n d the ligh t wil l tur n of f.
The alarm system is now disarmed.
Arme d
Enter Access code
1
2
3
E nter the premis es via the de s ignated entr y point,
the en tr y to ne will s o un d . P r oc e ed d ire c tly to th e
remote keypad.
3
3
If a valid Access code is not entered before the end of
the entry delay, an alarm will occur.
Disarming when not in Entry
To disarm the alarm system when not in entry, proceed
as follows:
The light will turn off. The a larm system is now
dis armed .
Armed
Press
Enter Access code
1
2
3
Press
3
3
If the system only has one partition you will not have to
perform step 2.
If the Quick Disarm feature is enabled and the system is
Stay armed you can omit step 1 from the above procedure.
Disarming after an Alarm
To disarm the alarm system after an alarm, proceed as
follows:
The system is disarmed and the keypads display the
source of the alarm.
Enter Access code
1
2
3
The system must now be reset before you can arm
again, see page 11 for details on resetting alarms.
Auto Stay Arming
If your installer has enabled the Auto Stay feature the system
will automatically Stay arm if the entry/exit zone (front door)
is not activated whilst attempting to Away arm the system.
To auto Stay arm your alarm system proceed as follows:
The light will flash and the exit tone will sound.A rmed
Press
Enter Access code
Press
1
2
3
Do NOT leave the premises d u ri n g the ex it d elay. At
the en d of the ex it d ela y the ala r m s y s te m will S ta y a r m.
Changing between Delayed and Instant Stay
When Stay arming the system the delayed zones (front door
etc) are normally delayed, i.e., when a delayed zone is
violated it will start the entry delay timer. However, it is
possible to change the delayed zones to instant when the
system is in a Stay armed mode. If a delayed zone is
violated when the system is in the “Instant Stay” mode the
system will generate an alarm immediately.
To change from Delayed Stay to Instant Stay, proceed
as follows:
The light will fla sh quic kly.
The sy stem is armed.
Armed
In s ta nt S ta y
Press and hold the key until you hear the
confirmation tone.
1
2
3
E ns u re th at the s ys tem is a rmed .S ta y
3
If the system is fitted with a Premier RKP8/16 Plus the
Instant light will also illuminate.
To change from Instant Stay to Delayed Stay, proceed
as follows:
The light will flash slowly.
The system is armed.
A rmed
De la yed S tay
Press and hold the key until you hear the
confirmation tone.
1
2
3
Ensure that the system is armed.I n s ta n t S ta y
3
If your system is fitted with a Premier RKP8/16 Plus the
Instant light will go off.
To Next Page
Loading...
