Texecom Premier Elite 24

Premier Elite Series User Guide
2 INS221-4
Overview
Introduction
Users of the alarm system will be assigned a unique 4, 5 or 6 digit User code, and may be assigned a Proximity Tag.
User codes are used to arm and disarm the system. Some User codes can also access additional options such as,
system tests and omitting zones.
Keypads will be installed throughout the premises, usually one at each entry/exit door. The keypads are used to
perform all of the system operations i.e. Arming, Disarming etc. Most User codes can be used at any keypad on the
system. However, Local Users will only be able to use certain keypads on the system.
The Emergency Keys
In case of emergency, the alarm system can provide three immediate emergency alarms by pressing and holding
two specific keys for two seconds.
Emergency
Alarm
Press Keys
 The emergency keys can be enabled/disabled for each keypad on the system. The
Panic alarm can be programmed for either audible or silent operation. The Panic
alarm can be programmed for either instant or delayed operation
Panic Alarm (PA)

&

Fire

&

Medical

&

The Quick Arm Keys
The ‘Quick Arm’ keys allow the system to be armed without having to enter a User code first.
 The ‘Quick Arm’ keys will only work if the keypad has been programmed to allow arming in this way.
To FULL arm the system, press

.
To PART arm the system, press

,

or

followed by

.
Keypad Lock
The keys on the keypad can be locked to prevent unwanted access to the system.
 The Emergency keys will NOT operate with the keys locked.
To Lock the keys press

and

together. To Unlock the keys, press

and

together again.
LED Indicators
Five LED indicators have been provided to indicate the status of the system.
LED Status Meaning
Power On AC mains is present on the control panel
Flashing AC Mains is not present, the control panel is running on the standby battery
Service On The system requires attention, contact your installer
Off The system does NOT require attention
Ready
On
All zones are secure and the system is ready to be armed
Off One or more zones are active
Flashing The system has zones (with the ‘Force Omit’ attribute) that are active
Info. On The system is armed (can also be programmed for other indications)
Off The system is unarmed (can also be programmed for other indications)
Omit On One or more zones are omitted
Off No zones are omitted