Premier Elite Series User Guide
INS221-4 5
To CLEAR an Arm Fail
When the system tries to arm with zones active (open), the internal sounders will sound and the external strobe will
be flashing to indicate a problem. For details on preventing an Arm Fail condition, please refer to page 3.
If you were not present when the Arm Fail occurred or you do not clear the Arm Fail, the internal sounders will continue to
sound and the external strobe will continue to flash.
1. Enter a valid User code
The internal and external sounders will stop, the external strobe
will continue to flash and the number of the zone that caused the Arm Fail will be displayed.
2. Enter a valid User code
and press
To SILENCE an Alarm
When an alarm occurs on the system, the internal and external sounders will normally sound for a pre-programmed
time (normally 15 minutes).
If you were not present when the alarm activated, the internal and external sounders may have already stopped but the
external strobe will still be flashing.
When alarm information is being displayed, pressing the SCROLL key will slow down the display and also allow manual
scrolling through the events.
1. Enter a valid User code
The internal and external sounders will stop and the number of the
zone that caused the alarm will be displayed. The alarm now needs to be reset.
To DISPLAY the cause(s) of System Alerts (Alarms)
When silencing an alarm or unsetting the system after an alarm, the number of the zone(s) will be displayed on the
keypad. If several zones were triggered, the display will scroll through each in turn.
After noting the cause of the alarm, the system can be reset as described in ‘RESET After an Alarm’ below.
System Alerts
When the system has faults to display, or has not been reset after an alarm condition, the display may show
‘SYSTEM ALERTS’.
Enter a valid User code
Any alarms or faults will be displayed. If several fault or alarm conditions have been triggered, the display will scroll
through each in turn.
After noting the cause of the alarm or fault, the system can be reset as described in ‘RESET After an Alarm’ below.
Some action may be required to clear the cause of the alarm or fault in order to successfully reset the panel.
To RESET After an Alarm
If the display shows ‘SYSTEM ALERTS’, follow the steps described in ‘To DISPLAY the causes of System Alerts’
above, before attempting to reset.
USER Reset
Once the alarm has been silenced (see page 5 for details), the system will need to be reset.
If the system has been programmed, to be reset by an Engineer, pressing
will not return the display to normal, if this is
the case see ENGINEER Reset for details.
The system may have been programmed to be reset by Anti-code, if this is the case, see ANTI-CODE Reset for details.
1. Enter a valid User code
2. Press
The external strobe will stop, the system will chime and the display will return to normal.
To Next Page
Loading...
