Premier Elite Series User Guide
4 INS221-4
To ARM Individual Areas
If the system has been split up into separate areas of protection i.e. Area 1 = House, Area 2 = Garage, Area 3 =
Shed etc. These areas can be individually selected for FULL or PART arming as required.
Areas are selected by using keys
-
(the
key can also be used to select an area followed by
or
).
On the 640 there are 4 Area groups, each with 16 Areas, these can be selected by pressing the
- key to select an
Area Group (1-4)
Only areas that exist on the system can be selected. (A ‘Star’ means the area can be selected and a ‘Dot’ means the area
cannot be selected).
Pressing
will select/deselect all areas, pressing
will toggle between the first 8 areas and the second 8 areas
(where applicable).
1. Ensure that the premises are secure (all windows and doors not being omitted are closed) and the Ready light
is on
2. Enter a valid User code
3. Press
4. Use keys
-
to select the required areas
5. Press
or
to FULL arm the areas Or on the 640 press
5. Press
,
or
followed by
or
(24/48/88/168) or (640)to PART arm the
areas The exit tone will sound (if silent arm has not been selected)
6. Leave the premises When the system has armed, the exit tone (if sounding) will stop
To DISARM the System
The entry time is divided into two sections, the Entry time and the 2
nd
Entry time. If the Entry time expires, an Internal
alarm will occur and the 2
nd
Entry time will start. If the 2
nd
Entry time expires, an Intruder alarm will occur (all internal
and external sounders).
It is perfectly normal for the 2
nd
Entry time to be programmed as zero, in which case, an Intruder alarm will occur as soon as
the Entry time expires.
1. Enter the premises via the designated entry point The entry tone will start
2. Enter a valid User code
The entry tone will stop
To DISARM the System When Not in Entry
1. Enter a valid User code
2. Press
To CANCEL the Exit Mode
Once the exit mode has been started you should leave the premises immediately, however, if for some reason you
decide not to leave, the exit mode must be cancelled.
1. Enter a valid User code
2. Press
The exit tone will stop.
To Next Page
Loading...
