Premier Elite Series User Guide
6 INS221-4
ENGINEER Reset
If the system has been programmed to be reset by an Engineer following an alarm activation, you will still be able to
silence the alarm by entering a valid User code (see page 5 for details).
The system cannot be armed again until the alarm has been reset.
1. Contact the telephone number on the display (if programmed) or the telephone number on the last page of
this User Guide
ANTI-CODE Reset
If the system has been programmed to be reset using an Anti-Code following an alarm activation, you will still be
able to silence the alarm by entering a valid User code (see page 5 for details).
The system cannot be armed again until the alarm has been reset.
1. Enter a valid User code
2. Press
The display will show a random code number i.e. 4281.
3. Contact the telephone number on the display (if programmed) or the telephone number on the last page of
this User Guide and quote the random code number You will be given a 4-digit Anti-Code i.e. 5624.
4. Enter the Anti-code that has been given to you
5. Press
If the Anti-code is correct, the keypad will bleep to indicate that the system has been reset and the
display will return to normal.
To OMIT Zones
It is possible to exclude (omit) individual zones when arming i.e. if a zone is ‘in fault’. Users with access to this function can
only omit zones that have been programmed as ‘Omittable’.
If the zone can be omitted, there will be a ‘Star’ to the right of the zone number. Only zones that have the ‘Omit’ attribute
assigned to them can be omitted.
A ‘Star’ will appear to the left of the zone number to indicate that the zone has been selected for omitting.
All omitted zones will be automatically reinstated the next time the system is disarmed, unless programmed otherwise.
To re-instate zones manually, simply follow the instructions again. However, when the
key is pressed on this occasion,
the zones will be re-instated.
1. Enter a valid User code
and press
2. Enter the zone number
3. Press
to omit the selected zone Repeat for other zones if required.
4. Press
when finished Continue to arm the system as normal.
To Next Page
Loading...
